air leak in the power tube in tippmann and bt and jts

[philmckool]

to fix this problem your going need this

wrench

prires

T-Tape or plummers tape

and your tools to take apart your gun

when you get the power tube out your gunna need a wrench to take off the hose

when you get it off your going to need the prires

this is for the power tube your going see the vavle pin in the power tube

you put the piries on that and pull out it should come out then check your orings and manul for that to make sure none are missing or broken

when you done that you put it all back to gether

then you put it in the power tube

now you going need the prires for this job do not push the vavle pin if you do you insides or the power tube will fall out the back this is what the prires are for

you going get the prires to push on the metal out side of the pin vavle so you dont losse all the stuff in side and have to do it all over again

when that done now you going need your T-tape for the hose wrape it on the threds and put it in the power tube and tighten it tell you can move it any more

heres a good trick if u have one if you have a remote line

you can do this attach your air supply to the hose where you whould then when you have the hose tight turn the remote line on and listion for leaks if u hear none then shut the tank off and leave it in

if you have a leak shut the tank off or tighten tell you hear no more leaks

then your done